Technology

Stainless Steel Wire Mesh Production Process:

• Release the selected weft wire, then draw the silk, be under annulus pressure and finally reach to the card device. At the early stage it doesn’t need the lubricant so as to block the filament, flat, hard wire, then put the weft into the tub filled with lubricant and wait for boot.
• Check the warp wire tension before booting the machine, and ask about the working conditions of the machines refueling the working parts of the the machine.
• After finishing the preparation work for starting the machine. A pre-boot is required in order to check the the extent of occlusion and dilute of the weft and warp wires. Starting the machine two to three times before turning into the normal operation.
• During the normal operating test the mesh with the density mirror, and repeatly check in a short period of time so as to discover and deal with the problems.
• Make the length mark with crayons at the net side, in order to make the measurement accurate, the length measure ruler should be kept by yourself.
• When the network reaching the required length make a rope to hang it, and weave a mesh around half a meter to rehang it.
• Finally is the unloading period. Keep the brackets installed and put the roll bar with slowly operating, so it can avoid the cracks on the surface and leaving crease. After finished the unloading, put the mesh in required place and make weaving record.